Table of Contents
Advertisement
NOTE:
You cannot use ORCA to configure a logical drive using RAID 0; you must use RAID
1+0 or higher. To configure a RAID 0 logical drive online, use the saconfig command. For
more information, see
NOTE:
You cannot use ORCA to configure a single spare drive to be shared among several
arrays. To configure shared spare drives, use the saconfig command. See
disk drive" (page
3.
To accept the settings, press Enter.
4.
To confirm the settings and save the configuration, press F8. After several seconds, the
Configuration Saved screen appears.
5.
To continue, press Enter.
6.
Create another logical drive by repeating steps 1-5 if necessary.
For more information on using ORCA, see
"Configuring a logical drive" (page
50).
"Using ORCA" (page
46).
53).
Configuring a Smart Array controller as a boot device
"Adding a spare
39
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Smart Array HP-UX 11i v2 and is the answer not in the manual?