Updating The Controller Firmware - HP Smart Array -UX 11i v2 Support Manual

5. Review the installation instructions and release notes on the download page.
6. Download the firmware.
7. To install the firmware update, follow the procedures supplied with the update package.

Updating the controller firmware

NOTE: The following is a generic procedure to update firmware from the EFI shell. HP recommends
that you follow the procedures supplied with the update package to install the firmware update.
To update the firmware image on the controller, use saupdate from the EFI Shell.
To update the controller firmware with saupdate:
1. Prepare to run saupdate from the Offline Diagnostics CD or the EFI partition:
To run saupdate from the Offline Diagnostic CD:
a.
b.
c.
d.
e.
To run saupdate from the EFI partition:
a.
b.
c.
IMPORTANT:
directory. If they are not, copy them to the EFI partition and run the saupdate from there.
28 Installing the controller
Download the firmware and copy it to the EFI partition.
Place the Offline Diagnostic CD containing saupdate.efi in the CD drive before
booting the system.
Boot the system to the EFI Shell prompt.
Locate the cdrom entry in the list of mapped devices, and change to the device by
entering its associated fs number (for example, fs0) under EFI Shell prompt.
If the EFI utility and firmware image files are not located in the root directory, move
to the directory where these files are located, for example:
fs0:\> cd \EFI\HP\TOOLS\IO_CARDS\SmartArray
Download the Smart Array EFI update utility saupdate.efi and copy it to the EFI
partition.
Download the firmware and copy it to the EFI partition.
Boot the system to the EFI Shell and change directories to the EFI partition.
The firmware image file and saupdate.efi must be located in the same