Updating Physical Disk Firmware Online - HP Smart Array -UX 11i v2 Support Manual

---- DRIVER INFORMATION ------------------------------------------------------
Driver State........................ READY
---- CONTROLLER INFORMATION --------------------------------------------------
Controller Product Number........... P400
Controller Product Name............. HP PCIe SmartArray P400
Hardware Path....................... 0/6/0/0/0/0/1/0/0/0
Device File......................... /dev/ciss5
---- FIRMWARE DOWNLOAD -------------------------------------------------------
** You are downloading the firmware image "INCPTR.PAK"
** to the controller "/dev/ciss5".
Retrieving firmware image file from disk................... [Done]
Validating the file's signature and size................... [Done]
Retrieving the firmware revision string from ROM........... [Done]
Retrieving the firmware revision string from the file...... [Done]
Current Revision (in ROM)....... 2.06
New Revision (in file).......... 2.08
WARNING: The firmware download process may take several minutes to
Are you sure you want to continue (y/n)? y
Preparing for download..................................... [Done]
Sending the new firmware to the controller................. [Done]
Activating the new firmware................................ [Done]
Resetting the controller................................... [Done]
Retrieving the firmware revision string from ROM........... [Done]
Current Revision (in ROM)....... 2.08
FIRMWARE DOWNLOAD WAS SUCCESSFUL!
******************************************************************************
****
******************************************************************************

Updating physical disk firmware online

The sautil physical disk firmware update command syntax is:
#sautil <device_file> download_dev_fw <fw_image> <physical drive id>
Where:
<device_file>
<fw_image>
<physical drive id>
80 Troubleshooting
complete. All I/O to this controller will be temporarily
halted during this time.
End of SAUTIL Output
The controller device file. Determine the Smart Array Controller
device file by entering the ioscan -kfn command as illustrated
in "Determining the Smart Array controller device file" (page
The file path for the firmware version you want to install on the
physical disk. For access to the physical disk firmware image update
file, contact your HP representative.
Either the Connector:Enclosure:Bay or WWID of the physical disk
where you want to change the firmware. You can determine the
****
34).