HP Smart Array -UX 11i v2 Support Manual page 127

see "The sautil <device_file> accept_media_xchg <logical_drive_number> command"
(page 77).
If auto-fail is disabled in the previous scenario, select one of the following options when the
Smart Array POST error is displayed:
1. Power off the server and reconnect the disks, and then power on the server.
2. Press F1.
The controller temporarily disables all logical drives, including the intact boot volume.
The server fails to boot.
3. Press F2.
The server takes the same actions as a system with auto-fail enabled, as previously
described.
For more information, see Appendix C (page 111).
127