Logic DLC NET Series Use And Maintenance Manual page 70

USE AND MAINTENANCE MANUAL – DLC
6.4.3 Dosing of manual
components (
LOGIC S.r.l. - M0145Db.docx
Mod. L0006A01 of 30/05/2016
NET
Series
appropriate corrections to ensure that anomalies fall and press
again.

If the checks are positive, the instrument gives consent to the dosage and
appropriately controls the valves according to the pre-action parameters
( ) and in flight amount (
6.1.2.

The product begins to flow and the weight indicator in the display begins to
increase.

On the instrument are activated two led:
o
Flashing led
component dosing
o
Flashing led
progress. This led will remain active until the recipe is not finished

It is possible pause the dosage by pressing the
will show

When it reaches the setpoint minus the in-flight amount, the system waits
for the waiting time of the in-flight set amount and shows the written
, acquiring the data weight for the printer.

At this point, the led corresponding to the component dosing is steady on,
indicating that the filling process is ended. The
and the dosage is terminated.

To dose a new automatic component repeat the full procedure. To dose a
manual component, follow the instructions in section 6.4.3.
)
In addition to the automatic components, it can be dose manual components that
are stored for printing.
To dose the manual component follow these steps:

Press the

The display will show the written (
automatic ingredient.

Press

Use the

The display shows the index of the next manual component to be dosed,
starting from 1.

Press
component.
) set and the logic described in paragraph
/ /
, which indicates that there is a recipe in
. Press to resume.
button to enter the ingredients selection menu (
at any time to cancel and return to the previous menu.
button until the manual component words (
to confirm and begin the dosing of the first manual
Use as a batcher
/ , indicating the automatic
button. The display
led continues to blink
), corresponding to the first
).
Page 70 of 78
).