Logic DLC NET Series Use And Maintenance Manual page 54

USE AND MAINTENANCE MANUAL – DLC
5.5.5 Serial port
configuration
( )
LOGIC S.r.l. - M0145Db.docx
Mod. L0006A01 of 30/05/2016
NET
Series

Enter the

Scroll through the button

Press to enter.

Press at any time to cancel and return to the previous menu.

The display shows the message with the filter value currently set (default
).

To change it use the button

Press to confirm.

At this point the instrument will show the letters
is finished.
The instruments of DLC
and one RS-232 (on the expansion board -EB), for simultaneous connection of
remote display and thermal printer.
For the instrument equipped with -EB expansion board are available three different
combinations:

: printer RS-232 and remote display DLC3-RD RS-485

: RS-232 printer and remote display BEKA

: remote display BEKA
Viceversa without -EB expansion board the only RS-485 port is available and two
configuration options:

: remote display DLC3-RD RS-485

: remote display BEKA
Over 15 m it is necessary to use the RS485 port.
To change the serial port configuration:

Enter the

Scroll through the button

Press to enter.

Press at any time to cancel and return to the previous menu.

The display shows the message with the serial port value currently set
(default ).

To change it use the button

Press to confirm.

At this point the instrument will show the letters
is finished.
menu as described in paragraph 5.3.2.
until the
until the desired item is not displayed.
NET
series are equipped with 2 serial ports, one RS-485
®
BA488C RS-232 and RS-485 printer
®
BA488C RS-485
menu as described in paragraph 5.3.2.
until the
until the desired item is not displayed.
Use as interface with indicator
menu.
and the procedure
®
BA488C RS-485
menu.
and the procedure
Page 54 of 78