USE AND MAINTENANCE MANUAL – DLC
5.4.5
Sensitivity correction
(
)
5.4.6
Zero scale calibration
(
)
LOGIC S.r.l. - M0145Db.docx
Mod. L0006A01 of 30/05/2016
NET
Series
At this point the instrument will show the written
procedure is finished.
The
procedure can be performed with the following steps:
Enter the
and press
Press
at any time to cancel and return to the previous menu.
The display shows the message
input the value of data weight to correct.
Press
to start editing the data. It is displayed the actual weight, with
the first digit flashing.
Use the button
editing the next one. Press
The display shows the message
should be displayed instead of the entered in
Use the buttons
next. Press
At this point the instrument will show the written
procedure is finished.
The
procedure can be performed with the following steps
From the main screen, press
with the button
Press
at any time to cancel and return to the previous menu.
The instrument will display the actual weight. Press again
the value of zero.
At this point the display will show
the instrument waits for the value of the weight added to the sample.
Enter the value of
the digit and
confirm.
menu, press the button
to enter the menu.
to increase the digit and
to confirm.
and
to increase the digit and move to the
to confirm.
and move inside the top-level menu
to the
menu. Press
to be reset using the button
to move on to editing the next one. Press
Use as interface with indicator
until the
, because the system waits for
to move on to
, the value that the instrument
.
to enter.
, with the first digit flashing,and
to increase
Page 50 of 78
and the
menu
and the
to edit
to
Need help?
Do you have a question about the DLC NET Series and is the answer not in the manual?