USE AND MAINTENANCE MANUAL – DLC
6.4 Dosing management
6.4.1
Introduction
6.4.2
Dosing of automatic
components (
LOGIC S.r.l. - M0145Db.docx
Mod. L0006A01 of 30/05/2016
NET
Series
The instruments of the DLC
manual components for a total of up to 14 steps of the recipe.
At each step, the operator selects to dose one of the 4 automatic components or a
manual component.
An automatic component can be dosed more times in the same recipe.
In the second case, the instrument manually increases the index of manual
components, so as to keep track of their number.
In the first dosage, automatically the system will start the recipe processing. If you
have a recipe in progress, the
The operator can then perform a series of dosages, automatic or manual, where
the sequence and dosing quantity will be stored for printing.
Once the entire sequence is complete, you can finish the recipe and print the
report of the whole process, including start time and end time recipe.
)
To dose the automatic components follow these steps:
Press the
The display will show the written (
automatic ingredient.
Use the
to confirm.
Press
The display shows
setpoint of the dosed.
Use the
to editing the next one and press
Now the display shows the flashing
confirmation that actually start the dosage.
The instrument then checks the following conditions:
o
Scale zero (
o
Maximum scale capacity (
If either one of the two conditions is not verified,
appears on the screen, according to the fault detected. Make the
NET
series allow the dosage up to 4 automatic and
led is blinking on.
button to enter the ingredients selection menu (
button to select the desired automatic ingredient and press
at any time to cancel and return to the previous menu.
with the first digit blinking and waits for the
button to increase the digit and the
, see section 6.2.1)
Use as a batcher
), corresponding to the first
button to switch
to confirm.
written, awaiting
, see section 6.2.2)
Page 69 of 78
).
or
Need help?
Do you have a question about the DLC NET Series and is the answer not in the manual?