Logic DLC NET Series Use And Maintenance Manual page 48

USE AND MAINTENANCE MANUAL – DLC
5.4.3 Calibration with
sample weights or
simulator (
LOGIC S.r.l. - M0145Db.docx
Mod. L0006A01 of 30/05/2016
NET
Series
)
To calibrate using sample weights or simulator you need to follow the procedure
in menu. Follow the instructions as follows:

Once in the
and press

Press

The display shows the message
first data the full scale of the weighing system.

Press
with the first digit flashing.

Use the button
editing the next one. Press

At this point will appear on the display
requires of the instrument.

Press
Use the button
to confirm and go to the next parameter.

The data later be requested is the value of zero scale. Is then displayed
the message
In the case of using a simulator for calibration of load cells, the user must
bring it on the indication 0 mV/V.
In the case of calibration with sample weights, the user must instead
discharge the weighing system.

If you press
unloaded scale. If the indication is correct, press again
next parameter.

The data later be requested is the value of the sample weight. Is then
displayed the word
In the case of calibration with simulator for load cells, the user must bring it
on the indication 2 mV/V (100% F.S.).
In the case of calibration with sample weights, the user must instead
indicate the chosen sample weight.
To maximize accuracy, it is recommended to apply a sample weight as close
as possible to the full scale and in any case not less than 50% of the same.
menu, press the button
to enter the menu.
at any time to cancel and return to the previous menu.
to start editing the data. It displays the full scale currently set,
to increase the digit and
to confirm.
to start editing the data. Display shows the full scale just set.
to select the decimal point position and press
.
, you see the actual value of the data weight, with
.
Use as interface with indicator
until the
, because the system waits as
to move on to
which is the decimal point
to go to the
Page 48 of 78
menu