USE AND MAINTENANCE MANUAL – DLC
5.4.4
Automatic calibration
(
)
LOGIC S.r.l. - M0145Db.docx
Mod. L0006A01 of 30/05/2016
NET
Series
If you press
balance loaded with the sample weight. If the indication is correct, press
again
to go to the next parameter.
At this point the display reads
instrument waits for the value of the weight added to the sample.
Enter the data using the button
move to editing to the next. Press
At this point the instrument will show the written
procedure is finished.
To make
procedure:
Enter the
and press
Press
at any time to cancel and return to the previous menu.
The display shows the message
first data the full scale of the weighing system.
Press
to start editing the data. It displays the full scale currently set,
with the first digit flashing.
Use the button
editing the next one. Press
At this point will appear on the display
requires of the instrument.
Press
to start editing the data. Display shows the full scale just set.
Use the button
to confirm and go to the next parameter.
The next data is the sensitivity of the cells (
editing. Use the button
The next data is the capacity of the load cells (
start editing. Use the buttons
move to the next. Press
, you see the actual value of the data weight, that is the
, with the first digit flashing, and the
to increase the digit and
menu, press the button
to enter the menu.
to increase the digit and
to confirm.
to select the decimal point position and press
to increase the digit and to confirm.
and
to confirm.
Use as interface with indicator
to confirm.
until the
, because the system waits as
to move on to
which is the decimal point
). Press
). Press
to increase the digit and
Page 49 of 78
to
and the
menu
to start
to
Need help?
Do you have a question about the DLC NET Series and is the answer not in the manual?