Table of Contents
Advertisement
Steps
1
Using Phillips #2 screwdriver, loosen the screws that secure the drive cage to the system.
2
Disengage the rear drive cage from the chassis by pushing it towards the front of the system and lift the drive cage away from the
system.
Figure 57. Removing the rear drive cage
Next step
Replace the rear drive
cage.
Installing the rear drive cage
Prerequisites
1
Follow the safety guidelines listed in
2
Power off the system and all attached peripherals.
3
Disconnect the system from the electrical outlet, and disconnect the peripherals.
4
Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5
Open the drive
bays, remove
6
Remove the
power supply
7
Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
8
Remove the system
cover.
9
Remove the air shroud.
10
Remove all the rear drives.
11
Disconnect all the cables from the rear drive backplane.
Steps
1
Lower the drive cage into the system and push the rear drive cage towards the rear of the system, until it is firmly seated.
2
Using Phillips #2 screwdriver, tighten the screws.
Safety
instructions.
all
drives, and then
close the drive bays.
units.
Installing and removing system components
85
Advertisement
Table of Contents
