Removing The Microsd Card - Dell EMC PowerEdge R240 Installation And Service Manual

Next steps
1. Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots that are based on the labels you had marked on the cards during
removal.
2. Install the air shroud.
3. Follow the procedure that is listed in

Removing the MicroSD card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Remove the IDSDM or vFlash module.
Steps
1. Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate
IDSDM/vFlash module, see the
2. Hold the MicroSD card and remove it from the slot.
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Figure 58. Removing the MicroSD card
Next steps
1. Replace the MicroSD cards.
After working inside your
Safety instructions.
Before working inside your
System board jumpers and connectors
system.
system.
section.
Installing and removing system components 61