Routine Operation - Raven SC1 Installation Manual

C 4
HAPTER
If serial 3D GPS OUT from the SC1 is needed, complete these steps:
1. Identify the 600S/700S installation cable (P/N 115-0172-285), not included in kit.
2. Connect one end of the installation cable to the 600S/700S.
3. On the other end of the installation cable, remove the black wire from pin #10 and remove the white wire from
pin #7 on the 12-pin Deutsch connector.
4. Populate the black wire in pin #7, and populate the white wire in pin #10 of the 12-pin Deutsch connector.
5. Connect the 600S/700S cable into the roof bulkhead.
6. On the SC1 harness, remove pin #1 from the gray SC1 connector and populate it in pin #9 of the gray SC1
connector.

ROUTINE OPERATION

FIGURE 10. Master and Resume Switch Locations
Master Switch
Locate and identify the machine's master switch on the control panel and the resume switch on the joystick as they
are required for SC1 system operation.
Refer to the Raven SC1 Guidance and Steering Calibration & Operation Manual (P/N 016-4010-005) for instructions
on Calibrating the SC1 system, adjusting system settings, and system operation.
20
Case IH Patriot 4440 - Steer Ready, Model Year 2017-18 Raven SC1 HDU Guidance and Steering Installation Manual
Resume Switch