Table of Contents
Advertisement
3-13 REAR JACK INSTALLATION
Two rear jack assembly is available for use on
the rear of the VT Plus.
3-13.1
On models built prior to November,
2009:
a. Attach rear jack mount and rear jack mount
plate weldment to the rear frame of the VT
Plus using 5/8-11 x 6 hex head cap screws
and hex lock nuts (See Figure 3-24).
IMPORTANT
THE REAR JACK TUBE SHOULD BE LOCATED
TO THE REAR OF THE VT PLUS NEAR THE
CENTER OF THE FRAME, BUT NOT INTERFER-
ING WITH THE VISIBILITY OF THE SMV SIGN.
b. Slide rear jack tube into rear jack mount
plate from the bottom and hold in desired lo-
cation with 5/8 detent pin with chain and 3/16
x 1-1/2 cotter pin.
3-13.2
On models built after November, 2009:
a. Slide rear jack assembly over rear frame of
the Vertical harrow near the center of the
frame.
b. Slide rear plate onto 3/4-10 x 4 hex head
cap screws beneath rear frame tube and hold
in place with 3/4-10 hex lock nuts.
3-32
5/8-11 HEX LOCK NUT
REAR JACK MOUNT PLATE
REAR JACK MOUNT
5/8 DETENT PIN
W/ CHAIN
5/8-11 X 6 HEX
HEAD CAP SCREW
REAR JACK TUBE
rear jack inst
Figure 3-24 Rear Jack Installation
(Prior to November, 2009)
REAR JACK ASSEMBLY
REAR FRAME
3/4W FLAT
WASHER
3/4-10 X 4 HEX HEAD
CAP SCREW GR5
REAR JACK PLATE
3/4-10 HEX LOCK
NUT GRB
m156953 installation
Figure 3-25 Rear Jack Installation
(After November, 2009)
REAR
FRAME
3/16 X 1-1/2
COTTER
PIN
Advertisement
Table of Contents
