Table of Contents
Advertisement
3-14 REAR JACK INSTALLATION (OPTION)
A rear jack assembly is available for use on
the rear of the Coulter Chisel. This is extremely
helpful if an attachment has been added to the
rear of the machine for stability.
3-14.1
Attach rear jack mount and rear jack
mount plate weldment to the rear frame of
the Coulter Chisel using 5/8-11 x 6 hex head
cap screws and hex lock nuts (See Figure
3-14).
IMPORTANT
THE REAR JACK TUBE SHOULD BE LO-
CATED TO THE REAR OF THE COULTER
CHISEL NEAR THE CENTER OF THE FRAME.
3-14.2
Slide rear jack tube into rear jack mount
plate from the bottom and hold in desired lo-
cation with 5/8 detent pin with chain and 3/16
x 1-1/2 cotter pin.
5/8-11 HEX LOCK NUT
REAR JACK MOUNT PLATE
REAR JACK MOUNT
5/8 DETENT PIN
W/ CHAIN
5/8-11 X 6 HEX
HEAD CAP SCREW
REAR JACK TUBE
rear jack inst
Figure 3-14 Rear Jack Installation
REAR
FRAME
3/16 X 1-1/2
COTTER
PIN
3-23
Advertisement
Table of Contents
