Table of Contents
Advertisement
Rear Jack Installation (Option)
A rear jack assembly is available for use on the rear of
the Coulter Chisel.
1. Slide rear jack assembly over rear frame of the
Coulter Chisel near the center of the frame (See
Figure 3-14.)
2. Slide rear plate onto 3/4-10 x 4 hex head cap screws
beneath rear frame tube and hold in place with
3/4-10 hex lock nuts.
ASSEMBLY INSTRUCTIONS
REAR JACK ASSEMBLY
REAR FRAME
3/4W FLAT
WASHER
3/4-10 X 4 HEX HEAD
CAP SCREW GR5
REAR JACK PLATE
3/4-10 HEX LOCK
NUT GRB
m156953 installation
Figure 3-14: Rear Jack Installation
3-21
Advertisement
Table of Contents
