Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Final Assembly
1. Attach a tractor to the implement and charge the lift
system hydraulics as described in "Hydraulic Lift
System" on page 4-3.
2. Install the 1-1/2 x 16 lockouts on both 3-1/2 x 16
cylinders on the frame.
3. Connect lights to the tractor and verify operation.
4. Check tires for proper inflation
5. Level the Weatherproofer I from front to rear as
described in "Leveling (Front-to-Rear)" on
page 4-4.
6. Inspect the final implement assembly, and verify that
all bolts have been tightened, cotter pins spread, and
that there are no leaking hydraulic connections.
Tighten all 1-3/4" nuts to 1,200 foot-pounds of
torque (See Figure 3-16.)
7. Rotate each disc gang to verify that each gang
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.
8. Lubricate the Weatherproofer I at all locations (See
"Lubrication Maintenance" on page 4-10.)
9. Touch up with paint any areas that may have been
scratched during moving, handling, or assembly.
10. Thoroughly read and understand the operating
section before using the Weatherproofer I.
4 FOOT
2 d410 010943
Figure 3-16: 1,200 Foot-Pounds of Torque
3-24
CAUTION
300
POUNDS
PULL
Rear Jack Installation
A rear jack assembly is available for use on the
Weatherproofer I combination finishing kits.
1. The rear jack assembly should be located on the
harrow arm tube assembly (See Figure 3-17.)
2. Slide rear jack mount plate onto 3/4-10 x 5 hex head
cap screws on top of harrow arm tube and hold in
place with 3/4-10 hex lock nuts (See Figure 3-18.)
rear jack stored
Figure 3-17: Rear Jack Location
3/4-10 HEX LOCK NUT
REAR JACK MOUNT
PLATE
HARROW ARM
TUBE
3/4-10 X 5 HEX HEAD
CAP SCREW
REAR JACK
ASSEMBLY
rear jack inst
Figure 3-18: Rear Jack Installation
HARROW ARM
TUBE ASSEMBLY
REAR JACK
(STORED)
F-620-0912 Edition
Advertisement
Table of Contents
