Additional Steps For Multi-Site Configurations - Western Digital ActiveScale P100 Support Manual

ActiveScale™ P100 Support Guide
0/49
0/49ScaleoutNetwork_InterconnectUp40G
(SiteN_System_Interconnect1) #show
0/51
0/51ScaleoutNetwork_InterconnectUp40G
(SiteN_System_Interconnect1) #exit
(SiteN_System_Interconnect1)
Connection
e. Create an alias on your laptop to System Interconnect 2 on the new system:
Note: Do not change the link-local IP address in the command below.
sudo ifconfig eth1:0 169.254.210.240 up
f. Connect to System Interconnect 2 (username:
lab@mw-von:~$ telnet 169.254.210.200
Trying 169.254.210.200...
Connected to 169.254.210.200. Escape character is '^]'.
User:admin
Password:
g. Run the following commands:
(SiteN_System_Interconnect2) >enable
(SiteN_System_Interconnect2)
(SiteN_System_Interconnect2)
(SiteN_System_Interconnect2)
(SiteN_System_Interconnect2)
(SiteN_System_Interconnect2)
(SiteN_System_Interconnect2)
(SiteN_System_Interconnect2)
(SiteN_System_Interconnect2)
(SiteN_System_Interconnect2) #write memory confirm
Config file 'startup-config' created successfully. Configuration Saved!
(SiteN_System_Interconnect2) #show
0/49
0/49ScaleoutNetwork_InterconnectUp40G
(SiteN_System_Interconnect2) #show
0/51
0/51ScaleoutNetwork_InterconnectUp40G
(SiteN_System_Interconnect2) #exit
(SiteN_System_Interconnect2) >q
Connection closed by foreign host.
6. If necessary, repeat all sub-steps in step 2 on system 3.

6.6 Additional steps for multi-site configurations

If you are scaling out a multi-site configuration, complete these additional steps before running the
configuration wizard:
closed by foreign
FullUnknown Inactive
interfaces
Full40G
>q
host.
, no password):
admin
#configure
(Config)#interface 0/49
(Interface 0/49)#no shutdown
(Interface 0/49)#exit
(Config)#interface 0/51
(Interface 0/51)#no shutdown
(Interface 0/51)#exit
(Config)#exit
interfaces
FullUnknown Inactive
interfaces
Full40G
94
status all | include
FullUnknown Active
status all | include
status all | include
FullUnknown Active