Table of Contents
Advertisement
ActiveScale™ P100 Support Guide
Warning: There is no lock or warning indication that the Storage Node is about
to come free from the rack. Use extreme caution.
6. Grasp the Storage Node and pull it out of the rack using even pressure.
7. Record the serial number for return purposes. The serial number and part number are located on a
pull-out tab located to the right of the SSD drive.
3.3.4.2 Installing a Storage Node
To install the replacement Storage Node:
1. Slide the Storage Node into the rack until it stops.
2. Tighten the thumb screws on the front of the Storage Node.
3. Replace the 2.5 inch drives. For more information, refer to
4. Replace the 3.5 inch drives. For more information, refer to
5. Reconnect all of the cables in the original configuration. For more information, refer to
on page 66.
6. Power on the Storage Node using the power button on the front panel.
7. If Western Digital Corporation support is not onsite, contact customer support for the final post-
replacement procedures for bringing the Storage Node online.
3.4 Mounting kit replacement instructions
ActiveScale systems can use different rail kits for each component. Use the following table to determine
which sections are relevant for your mounting kits.
Component
System Node
System Interconnect
Storage Node
Mounting kit type
1U
3U
3U
1U
3U
55
Installing a 2.5 inch drive
Installing a 3.5 inch drive
Relevant topics
•
Replacing System Node 1U
mounting kits
on page 59.
•
Replacing 3U mounting kits
on page 56.
•
Replacing 3U mounting kits
on page 56.
•
Replacing Storage Node 1U
mounting kits
on page 61.
•
Replacing 3U mounting kits
on page 56.
on page 52.
on page 50.
Cabling map
Advertisement
Table of Contents
