Installing A System Interconnect Psu; Figure 3-28. Latch Release Lever And Handle; Figure 3-29. Removing The Psu - Western Digital ActiveScale P100 Support Manual

ActiveScale™ P100 Support Guide
1. Remove the blanking panel from the System Interconnect mounting kit.
a. Remove the thumb screw from the front of the blanking panel.
b. Grasp the blanking panel by the front cutouts.
c. Pull the blanking panel from the mounting kit.
Note: You might have to remove adjacent blanking panels to fully access the 3U
mounting kit or System Interconnects.
2. Remove the PSU power cable.
3. Press the latch release lever. This action releases the PSU from the System Interconnect.

Figure 3-28. Latch release lever and handle

4. Grasp the handle and pull with even pressure until the PSU is removed from the system.

Figure 3-29. Removing the PSU

5. Record the serial number of the faulty device for return purposes.

3.2.2.2 Installing a System Interconnect PSU

To install a replacement System Interconnect PSU:
43