Programming The System Interconnects - Western Digital ActiveScale P100 Support Manual

ActiveScale™ P100 Support Guide
Table 7-3. Multi-site example configuration
Rack
Scale out rack 3
Scale out rack 4
Scale out rack 5
Scale out rack 6
Scale out rack 7
Scale out rack 8
Important: If you are installing System Expansion Nodes in multiple racks,
install all of the kits in a single rack before moving on to the next rack.

7.7 Programming the System Interconnects

After cabling the System Expansion Nodes, log into the System Interconnect and open ports 38 (for
System Expansion Node 1), 40 (for System Expansion Node 2) and 42 (for System Expansion Node 3).
Note: The VLANs on each port will be automatically enabled while running the
System Expansion Node configuration wizard.
To program each System Interconnect:
System Expansion Nodes per
ActiveScale P100 ActiveScale
X100 system
3
3
2
1
1
2
21 total
109