Western Digital ActiveScale P100 Support Manual page 94

ActiveScale™ P100 Support Guide
1. Reconfigure the System Interconnects on the existing system:
a. Connect an Ethernet cable from your laptop to port 44 on System Interconnect 1 of the existing
system.
b. Reconfigure the System Interconnects on the existing system:
a. Create an alias on your laptop to System Interconnect 1 on the existing system:
Note: Change the IP address in the first alias to match your network settings, but
do not change the link-local IP address in the second alias.
sudo ifconfig eth1:0 172.16.110.240 up #this IP address should match
your setup
sudo ifconfig eth1:1 169.254.110.240 up
b. Connect to System Interconnect 1 (username:
lab@mw-<SystemIP>: $ telnet <IP_of_System_Interconnect_1> lab@mw-
SystemIP: $ telnet IP of System Interconnect 1 Trying
172.16.110.200...
Connected to 172.16.110.200. Escape character is '^]'. User:admin
Password:
c. Run the following commands:
(SiteN_System_Interconnect1)
(SiteN_System_Interconnect1)
(SiteN_System_Interconnect1)
(SiteN_System_Interconnect1)
(SiteN_System_Interconnect1)
(SiteN_System_Interconnect1)
(SiteN_System_Interconnect1)
(SiteN_System_Interconnect1)
(SiteN_System_Interconnect1)
(SiteN_System_Interconnect1) #write memory confirm
Config file 'startup-config' created successfully. Configuration Saved!
(SiteN_System_Interconnect1)
include 0/49
0/49ScaleoutNetwork_InterconnectUp40G
(Site1_Storage_Interconnect1) (Config)#show interfaces status all |
include 0/51
0/51ScaleoutNetwork_InterconnectUp40G
(SiteN_System_Interconnect1) (Config)#exit
2. Create an alias on your laptop to System Interconnect 2 on the existing system:
Note: Change the IP address in the first alias to match your network settings, but
do not change the link-local IP address in the second alias.
sudo ifconfig eth1:0 172.16.210.240 up #this IP address should match
your setup
sudo ifconfig eth1:1 169.254.210.240 up
3. Connect to System Interconnect 2 (username:
lab@mw-<System IP>:$ telnet <IP of System Interconnect 2> Trying
, no password):
admin
>en
#conf
(Config)#interface 0/49
(Interface 0/49)#no shutdown
(Interface 0/49)#exit
(Config)#interface 0/51
(Interface 0/51)#no shutdown
(Interface 0/51)#exit
(Config)#exit
(Config)#show interfaces
Full40G
FullUnknown Inactive
, no password):
admin
92
status all |
FullUnknown Active