Table of Contents
Advertisement
ActiveScale™ P100 Support Guide
b. Position the hook on the rear outer rail around the rear vertical rail.
c. Slide the rear outer rail pegs into the desired slots.
d. Position the hook on the rear outer rail over the rear vertical rail and then slide the rear outer rail
pegs into the desired slots. The clip at the rear of the rail kit is installed over the rack rail to hold it
in place.
Figure 7-3. Rail attaching to rear vertical rail
e. Extend the outer rail forward and insert the pegs into the front vertical rail.
Figure 7-4. Rail attaching to front vertical rail
f. Extend the inner rail to its full length.
g. Remove the inner rail by sliding the white clip with a rounded edge forward.
Note: Be cautious leaving the outer rails extending out of the rack. Consider
pushing the outer rails back until you are ready to install the node.
106
Advertisement
Table of Contents
