Safety; Safety Guidelines; System Set-Up; Mounting Options - Pace HW 100 HeatWise Operation And Maintenance Manual

Safety

Safety Guidelines

The following are safety precautions that personnel must understand and follow when using or
servicing this product.
1. POTENTIAL SHOCK HAZARD - Repair procedures on PACE products should be performed
by Qualified Service Personnel only.
equipment is disassembled. Service personnel must avoid contact with these parts when
troubleshooting the product.
2. To prevent personnel injury, adhere to safety guidelines in accordance with OSHA and other
applicable safety standards.
3. Heater Cartridge Tips are hot when the handpiece is powered on and for a period of time
after power off. DO NOT touch the cartridge. Severe burns may result.
4. PACE Tip & Tool Stands and handpiece cubbies are designed specifically for use with the
associated handpiece and houses it in a manner that protects the user from accidental burns.
Always store the handpiece in its holder. Be sure to place the handpiece in its holder after
use and allow for cooling before storing.
5. Always use PACE systems in a well ventilated area. A fume extraction system such as those
available from PACE are highly recommended to help protect personnel from solder flux
fumes.
6. Exercise proper precautions when using chemicals (e.g., solder paste). Refer to the Material
Safety Data Sheet (MSDS) supplied with each chemical and adhere to all safety precautions
recommended by the manufacturer.

System Set-Up

Set up the HW 100 or TW 100 systems using the following steps and associated
images.
1. Store the shipping container in a convenient location.
containers will prevent damage if you store or ship your system(s).
2. Place the Power Switch in the "OFF" or "0" position.

Mounting Options

The HW 100 and TW 100 can be placed directly on a work surface or can be
mounted under a workbench or shelf to conserve space using the optional power-
source mounting bracket. To mount the system in this way:
1. Mount the bracket in the desired location (fasteners not supplied).
2. Remove the top two screws from the power source case.
3. Fit power-source to mounting bracket
4. Replace power source screws and tighten by hand.
Tip & Tool Stand
The Tip & Tool Stand is usually placed on the workbench next to the power
source. It can also be mounted to the power source using the optional Power
Source/Tool Stand Interlock (P/N 1335-0251-P1).
When the Interlock bracket is used, the Tool Stand
may be attached to a power-source that has been
mounted under a workbench or shelf. It is important to
note that the Interlock can be mounted on either side
of the power-source. In the examples below, the Tool
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Line voltage parts may be exposed when the
Reuse of these
On/Off
Switch
Page 5 of 17