4. Lock the outfeed table
Figure S
Test Run
WARNING!
Long hair, loose clothing and jewelry can get
caught up in the moving parts of machinery and
result in serious injury. Keep Long hair and loose
clothing tied up and away from the machine.
Remove jewelry prior to use.
WARNING!
Chips and pieces of stock may be thrown from the
machine. This can cause eye injuries, wear safety
glasses at all times.
1. Before starting the machine, read the
instruction manual in its entirety.
2. Check that the cutterhead guard has
been installed correctly
3. Remove all tools and foreign objects
from the machine.
4. Review
the
Requirements and connect to the
power source
5. Press the START button to turn on the
machine.
The jointer should run smoothly with no
vibration. Immediately stop the machine if you
suspect any problems and refer to the trouble
shooting section of this manual before re‐
starting.
Recommended Adjustments
Your machine has been factory preset so very
little if any re‐adjustments should be
necessary,
unforeseen problems in the shipping process
we recommend that you verify the following
to ensure the best possible results from your
machine.
Step by step instructions for these
adjustments can be found in the SERVICE
section of this manual
OPERATIONS
Operation Safety
Always wear safety glasses, a respirator, and
hearing protection when operating this
machine, damage to your eyes, lungs, and ears
may result without the proper protective gear.
Long hair, loose clothing and jewelry can get
section
Circuit
caught up in the moving parts of machinery
and result in serious injury. Keep Long hair and
loose clothing tied up and away from the
machine. Remove jewelry prior to use.
15
however
1. Knife setting
2. Depth Scale calibration
3. Fence Stop Accuracy
WARNING!
WARNING!
because
of
any