Assembly & Adjustments - Craftex CS Series User Manual

ASSEMBLY AND ADJUSTMENTS
WARNING: If any part is missing or damaged, do not plug the drill press in
until the missing or damaged part is repaired or replaced.
Tools needed for assembly
 Socket wrench
 Screwdriver

Hammer and block of
wood
Assembly:
The column assembly (column,
column support, rack, rack collar,
and table support bracket) must
be attached to the base. The
table and table support handles
must be attached to the table
support bracket. The motor
housing must be attached to the
column.
COLUMN ASSEMBLY TO BASE (Fig. 3)
1.) Place the column column base (1)
on the base (2), aligning the
column support holes to the base
holes.
2.) Install a hex head bolt (3) in each
column support hole and tighten
bolts using the socket wrench.
Fig. 3
Insert the pinion into the hole on the
side of the table support bracket from
the inside, starting with the pinion
shaft. Figure 3.
Examine the rack and note that the
gear teeth extend further on one end
than the other. The shorter end must
be positioned down. Insert the rack
into the table support bracket and
align with pocket so that the gear
teeth mesh with the rack teeth. The
end of the rack where the gear teeth
are closest to the end should be
positioned down. Slide the table
support bracket and rack onto the
column.
10