Circuit Requirements; Plug And Grounding Requirements - Craftex CX Series Manual

FULL LOAD CURRENT RATING
This is the amount of Amps a machine
draws under 100% of the rated output
power.
FULL LOAD RATING FOR 120V
15AMPS
The full load current is not the maximum
amount of amps the machine will draw.
The machine has potential to draw current
beyond the full load rating if it is
overloaded. Overloading of the machine
for an extended period of time can cause
damage, overheating, or even fire. The
risk is higher if the machine is on an
undersized circuit. To help avoid these
issues insure you are connected to a
circuit in which meets the specified circuit
requirements for this piece of machinery.
WARNING!!!
Do not connect machine to power
before setup has been fully completed
to avoid risk of personal injury or
property damage.
CIRCUIT REQUIREMENTS FOR
CX06Z JOINTER
The CX06Z has been prewired at the
factory for operation on an electrical circuit
that has a verified ground and meets the
following requirements:
Voltage:
Cycle:
Phase:
Circuit Breaker Size:
Please Note:
1. An electrical
electrical equipment
breaker panel and the machine. This is
why it is important to have the proper
circuit size
accommodate this machine under full
load for an extended period of time.
2. The circuit requirements laid out in this
manual are for a dedicated circuit in
which only one machine will be
operational or installed at a time.
3. If you choose to connect to a shared
circuit where more than one machine
may be running at a time please
consult with a qualified electrician to
insure the circuit is properly sized for
safe operation.
PLUG AND GROUNDING
REQUIREMENTS
This machine must be grounded so that in
the event of certain malfunctions it will
6
110V – 120V
60Hertz
Single
20Amps
circuit includes
between the
so it can safely
all