Figure O
Table Controls Installation
Components & Hardware Required:
Qty
Outfeed Table Handle
Infeed Table Lever
Phillips Head Screws M5‐.8 x 15
Flat Washers 5mm
Tools required:
Phillips Head Screwdriver
19mm Wrench
1. Remove the screw & flat washer
already mounted in the infeed handle
shaft.
2. Mount & secure the handwheel to shaft
as in (Fig. P)
3. The outfeed handle is pre‐ installed
Figure P
1
1
1
1
Qty
1
1
Outfeed Table Height Setting
The outfeed table needs to be at the same height
as the cutterhead knives when at top dead centre.
This adjustment is preset at the factory but should
be checked before you use your jointer. This
adjustment must also be made whenever you
change the cutterhead knives.
1. Place a straightedge on the outfeed table
and extend it over the cutterhead.
2. Rotate the cutterhead until one of the
knives is at top dead center (TDC), as
shown in (Fig.Q)
Figure Q
3. Raise or Lower the outfeed table until the
knife touches the straightedge
Figure R
14