Adjustments; Changing Spindle Speeds; Adjustments Changing Spindle Speeds; Table Adjustments - Craftex CT024N Owner's Manual

Adjustments

CHANGING SPINDLE SPEEDS

Disconnect the drill press from its power source.
Open the pulley cover.
Loosen the slide bar knob
Move the motor to the front to loosen the tension on both belts.
Relocate the belts to the pulley steps appropriate to the required spindle speed
To tighten the belt tension, move the motor toward the rear of the drill press.
Tighten the slide bar knob
Close the pulley cover.
Test run the drill press to check the belts for proper tension.

TABLE ADJUSTMENTS

To tilt the table from 0 degrees to 45 degrees left or right, loosen the table locking
bolt, tilt the table to the desired angle and tighten the bolt.
When returning the table to 0 degrees tighten the bolts.
11