Repeat steps 5 – 7 with the rest of the
knives.
8. Rotate the cutterhead to the first knife
you started with, and then slightly
tighten all the gib bolts. Start at the
ends and work your way to the middle,
alternating left and right. Repeat with
all the knives.
9. Finally tighten each gib bolt.
10. Adjust the outfeed table to match the
new knife heights.
Depth Scale Calibration
1. Set the Outfeed table height as
described in Setting the Outfeed Table
Height sub‐section.
2. Place a straightedge across the infeed
and Outfeed tables.
3. Adjust the infeed table until it is level
with the Outfeed table. (Fig.II)
Figure II
4. Using a screwdriver, adjust the scale
pointer exactly to "0" (zero) (Fig.JJ)
Figure JJ
Setting the Fence Stops
Fence stops are adjustable nuts and bolts to
simplify the task of adjusting the fence to 45
deg. inward, 90 deg., and 45 deg. outward
(135 deg.)
Setting the 45 deg. Inward Fence Stop
1. With a 45 deg. square, adjust the fence
to the 45 deg. inward position.
Figure KK
2. Loosen the jam nut (Fig.LL)
Figure LL
3. Adjust the 45 deg. inward fence stop
nut until it makes contact with the
back of the fence bracket, then re‐
tighten the jam nut from Step 2 and
recheck.
24