Figure I
Assembling the Fence
Components & Hardware Required:
Fence Assembly
Cap Screws M8‐1.25 x 25
Lock Washers 8mm
Flat Washers
Fence Tilting Handles
1. Fasten the fence assembly to the fence
carriage using the M8‐1.25 x 25 cap
screws and washers supplied as in (Fig.
J)
Figure J
Qty
1
2
2
2
2
2. Thread the fence tilting handle into the
fence assembly as in (Fig. K)
Figure K
Cutterhead Guard
CAUTION!
The cutterhead guard is a critical safety
feature on this jointer and care must be taken
in installation. The guard has a torsion spring
mounted within it to allow it to return to its
proper position after a jointing operation. The
spring must have spring pressure during the
installation to operate correctly.
Components & Hardware Required:
Cutterhead Guard
Tools required
:
2.5mm Hex Key
1. Remove the set screw in the
cutterhead guard shaft as in (Fig. L)
12
Qty
1
Qty
1