Figure F
Carriage Mounting Bracket
Components & Hardware Required:
Carriage Mounting Bracket
Cap Screws M8‐1.25 x 60
Lock Washers 8mm
Flat Washers
Tools required:
6mm Hex Key
1. Align the locating pins on the back of
the carriage mounting bracket with the
sockets on the jointer table as shown
in (Fig. G)
Figure G
Qty
1
4
4
4
Qty
1
2. Tighten the carriage mounting bracket
to the jointer table with the cap
screws, lock washers & flat washers
supplied. (Fig. H)
Figure H
Assembling the Fence Carriage
Components & Hardware Required:
Fence Carriage Assembly
Cap Screws M8‐1.25 x 20
Lock Washers 8mm
Flat Washers
Tools required:
6mm Hex Key
1. With the fasteners listed above, secure
the fence carriage to the Carriage
mounting bracket as in (Fig. I)
11
Qty
1
2
2
2
Qty
1