Test Run - Craftex CX series User Manual

8. To lock the fence into place you must
tighten the fence carriage locking lever.
9. To attach the handles to the infeed/
outfeed tables you will require (2) M6-1
x 20 cap screws, (2) 6mm lock washers,
and (2) 6mm flat washers.
OPTIONAL: HOOK UP
TO DUST COLLECTOR
1. Remove the existing dust bag and
hose c l a m p f r o m t h e 2 - 1 / 2 " d u s t
co llection port.
2. Slide a 2-1/2" piece of hose on the
dusts port and fasten it in place using
the appropriate hose clamp.
3. Make sure that the hose is secured
tightly and the seal between the hose
and dust port is air tight in order to
prevent loss of suction and ensure
proper performance.

TEST RUN

Now that you have completed the assembly
of your machine it is time for the test run.
The test run is to confirm that everything is
functioning as it should.
If you do happen to encounter any unusual
issues or problems stop the machine
immediately and disconnect it from the
power supply. The issues must be fixed
before operation of the machine. The trouble
shooting section is located in the service
and maintenance part of the manual it may
be of help.
The test run is used to confirm the following:
1. T hat t he mot or energ izes a n d
runs properly.
2. That the main switch with the safety
key function as intended.
NOTE
17