Setting the 90 deg. Fence Stop
1. Flip the 90 deg. swing stop into the
position as in (Fig.MM)
Figure MM
2. With a 90 deg. square, adjust the fence
to the 90 deg. position (Fig.NN) using
the fence stop bolt and jam nut.
Figure NN
3. Loosen the jam nut on the 90 deg.
fence stop bolt (Fig.MM)
4. Adjust the 90 deg. fence stop bolt until
it contacts the 90 deg. swing stop, then
re‐tighten the jam nut from Step 3 and
recheck.
Setting the 45 deg. Outward Fence stop,
1. Flip the 90 deg. swing stop out of the
way (Fig.OO)
2. Using a sliding bevel adjusted to 135
deg., adjust the fence to the 135 deg.
(45 deg. outward) position.
Figure OO
Loosen the jam nut on the 45 deg.
3.
outward fence stop bolt (Fig.MM)
4. Adjust the 45 deg. outward fence stop
bolt until it contacts the 90 deg. swing
stop, then re‐tighten the jam nut from
Step 3 and recheck.
Adjusting the Gibs
The purpose of the table gibs is to eliminate
excessive play in the table movement. They
also control the smoothness of the table
movement.
1. With a 10mm wrench, loosen the two
outfeed table gib nuts on the side of
the jointer base (Fig.PP)
Figure PP
25