Basic Controls; Test Run - Craftex CX12HC User Manual

BASIC CONTROLS

The basic controls of the jointer are shown
in the figure below. Use this figure and read
the text to know what the basic controls of
your machine are.
Figure-6 Basic Controls
A. ON/OFF SWITCH: Starts and stops the
jointer.
B. FENCE ADJUSTMENT KNOB: Moves
the fence forward or backward.
C. TABLE ADJUSTMENT LEVERS: Move
the table forward and backward.
D. TABLE LOCKS: Lock the tables to the
position desired position.
10

TEST RUN

Once you have assembled your machine
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
TO TEST RUN THE MACHINE:
Make sure you have read and understood
the safety instructions given in the manual.
Connect the machine to correct power
source.
Make sure all the tools and objects used
during setup are cleared away from the
machine.
Turn the machine ON and let the machine
run for a few seconds.
Press stop button to turn OFF the machine
and restart the jointer.
Listen and watch the machine for any
unusual noises. The machine should run
smoothly with little or no vibration.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates, immediately shut off the
machine and investigate to find out the
problem with your machine.
WARNING!
Before starting the jointer please make
sure that you have read and understood
the manual and you are familiar with the
functions and safety features on this
machine. Failure to do this may cause
serious personal injury.