Figure L
2. Wind the torsion spring knob back
counterclockwise a half turn, then slide
the guard shaft into the casting as
shown in (Fig. M) ensuring the slot on
the cutterhead guard shaft fits over
the pin that is inside the spring knob
barrel (hidden from view).
Figure M
3. Test the guard by pulling it back and
letting it go
The safety guard should snap back
quickly covering the cutterhead
completely, then re‐insert the set
screw as in (Fig. N)
If the guard is slow to return,
remove the shaft and add another
half turn to the spring knob and
test again. Repeat as necessary.
Figure N
Dust Port Installation
Components & Hardware Required:
Dust Port
Phillips Head Screws M5‐.8 x 15
Flat Washers 5mm
Tools required:
Phillips Head Screwdriver
If you do not choose to use a dust collector,
do not install the dust port. Chips will build up
within the cabinet and clog the machine.
1. Place the dust hood over the dust vent
on the cabinet and with the four
screws & washers secure it to the
cabinet (Fig. O). Then attach to the
dust collection system.
13
Note:
Qty
1
4
4
Qty
1