Adjustments; Changing Spindle Speeds - Craftex CX614 User Manual

ADJUSTMENTS

CHANGING SPINDLE
SPEEDS
Disconnect the drill press from the power
source.
Open the pulley cover.
Loosen the slide bar knob (1).
Move the motor to the front by using shifter
bar to loosen the tension on both belts.
Relocate the belts to the pulley steps
appropriate to the required spindle speed
(2).
To tighten the belt tension, move the motor
by using the shifter bar toward the rear of
the drill press.
Tighten the slide bar knobs (1).
Check the belts for proper tension.
Close the pulley cover.
TABLE ADJUSTMENTS
Raise or lower the drill press table by
loosening the column lock lever (1) and
turning the rack and pinion handle (2) to the
desired elevation. Securely tighten the
column lock before using the drill press.
To rotate the table around the post, loosen
the column lock lever. Secure the column
lock before operating the tool.
To rotate the table only, loosen the table
lock (3). Do not operate the drill press
without tightening the table lock lever.
To tilt the table from 0 degrees to 45
degrees left or right, remove the pin (4) and
nut (5). If the pin sticks, rotate the nut (5)
clockwise until the pin slips out. loosen the
table locking bolt (6), tilt the table to the
desired angle and tighten the bolt (6).
When returning the table to 0 degrees,
replace the pin (4) and tighten bolts (5) and
(6).
12