FRONT EXTENSION ARMS
TO INSTALL THE FRONT EXTENSION
ARMS:
Loosen the four bolts on the front table.
Place the front extension arms over the
bolts and behind the special washers.
Align the channel of the front extension arm
with the channel on the side.
Make sure the ground flat surface on the
front extension arms are flush with the top
of the table surface.
Tighten the bolts and check to make sure
your alignments are still intact. See figure-2.
Figure-2 Front extension arm
REAR EXTENSION ARMS
Slide the rear extension arms into the
socket on the back of the table with the
scales face.
Tighten the set screws.
Attach the rear stop to the rear extension
bars and secure with the thumb screws
provided. See figure-3.
Figure-3 Installing rear extension arm
HOLD DOWN
ADJUSTMENT
TO ADJUST THE HOLD DOWN:
Tighten the hex nut on the top of the spring
to raise the hold down off the table.
Insert the shim under the hold down finger,
turn the hex nut to lower the hold down until
it makes light contact with the shim.
Repeat the above steps at the other sides
of the shear.
Tighten the two fixing bolts on the front of
the hold down securing it in place. See
figure-4.
Figure-4 Adjusting the hold down
7