Table of Contents
Advertisement
UNPACKING
The CX817N is properly packaged in
a
carton
for
When
unpacking, carefully inspect the
carton and ensure
been damaged during transit.
While doing the inventory if you can not find
any parts, check if the part is already
installed on the machine.
WARNING!
The CX817N is a very heavy machine.
Do not
overexert
forklift or other mechanical device to lift
and move the shear.
MOUNTING
CX817N
The
features
holes on its base which allow mounting it
to the shop floor. It is recommended to
mount the shear to the shop floor for
safety and to offer
performance.
Mounting hardware is not
included with the machine.
Lag shield anchors with lag bolts and
anchors studs are two popular methods for
mounting the machine to the concrete floor.
Anchor studs are stronger and more
permanent alternatives to the lag shield
anchors.
6
safe
transportation.
that
nothing
has
yourself.
Use
four
pre-drilled
the
best
overall
FOOT PEDAL
To assemble the foot pedal you will need
the help of an assistant.
TO INSTALL THE FOOT PEDAL:
Loosen the set screws holding the hinge
pins in place and slide them outward.
Lift the foot pedal with the help of an
assistant and position it over the hinge pin
hole and insert the hinge pin.
Secure it by tightening the set screws.
a
Link the two swivel bottoms through the
side arms of the foot pedal with the
supplied bolts and tighten in position. See
figure-1.
Figure-1 Foot pedal assembly
Advertisement
Table of Contents
