Mounting The Machine On To The Stand; Installing The Dust Ports - Craftex CT180 User Manual

Place the stand upside down on the floor
and attach the four rubber feet to the each
leg securing it with the nuts and washers
provided. See figure-5.
Figure-5 Installing the rubber feet
Place the stand up right and adjust the
rubber feet making sure that the stand is
level from all four sides and tighten the lock
nuts on the rubber feet.
MOUNTING THE MACHINE
ON TO THE STAND
Lift the sander up using a fork truck or any
other mechanical device and align the four
holes on the sander base with the holes on
the four corners of the stand. Slowly, lower
the machine onto the stand and secure it
from underneath the stand using bolts and
washers provided. See figure-6.
Figure-6 Securing sander to the stand
INSTALLING THE DUST
PORTS
Install the dust ports to the back of the
sanding belt frame and to the bottom of the
sanding disc cover using the screws and
washers provided. See figure-7.
Figure-7 Dust ports
Once the dust ports are installed, attach the
coupler to the sanding belt dust port as
shown in figure-8.
Figure-8 Installing the coupler
10