Mounting The Drill Press; Installing The Arbor And Chuck - Craftex CS Series User Manual

Table of Contents

SPEED HANDLE (Fig. 7)

1. Insert the feed handle (1) into the

threaded opening on the speed hub (2).

2. Manually tighten handle into opening.

Fig. 8

Mounting the Drill Press

The Drill press should be secured to the

floor to give stability to the drill press to

prevent the drill press from tipping over

Fig. 9

Install the chuck

1. Inspect and clean the taper hole in the

chick and the spindle. Remove all

grease, oil and particles from the chuck

and arbor surfaces with a clean cloth.

2. Open the chick jaws by manually turning

the chuck barrel clockwise. Make sure

the haws are completely recessed

inside the chuck.

3. Insert the chuck arbor into the chuck

4. Seat the chuck and chuck arbor on the

spindle by placing a block of wood with

a hammer (not included) Or tap the

chuck with a rubber mallet (not included)

Table of Contents

Cx618