Bench Mounting & Assembly - Craftex CX series User Manual

BENCH MOUNTING
On the base of the machine are mounting
holes that allow for the machine to be fas-
tened to a workbench to prevent machine
from moving during operation
The strongest method is a through mount
where holes are made all the way through
the work bench and hex bolts, washers, lock
washers, and hex nuts are used to securely
fasten the machine to mounting surface.
ASSEMBLY
The Machine must be completely assembled
before operation. Before you begin the pro-
cess of assembly make sure to thoroughly
clean all parts that are coated in packing
grease or rust preventative.
1. To attach the carriage support to the
jointer you will need (2) M8-1.25x10
cap screws, (2) 8mm flat washers, as
well as (2) 8mm Lock washers. See
picture below:
2. P lace the locking plat e ass e mb l y
into the carriage support so that the
locking plate pins are against bottom
edge of carriage support. Now attach
the fence carriage lock lever and 10
x 3.5mm beveled washer on locking
plate. Assemble as shown in pictures
below: (DO NOT FULLY TIGHTEN YET)
3. Push down on the limit plate tab on
the carriage assembly then place the
limit block with notched side facing up.
15