MOUNTING ON A
WORKBENCH
The CT188 features two pre-drilled holes
on its base which allow mounting the buffer
to the workbench.
There are two ways to mount the buffer
onto the workbench; through mount and
direct mount.
"Through Mount" is the strongest mounting
option where the holes are drilled all the
way through the workbench. Hex bolts,
washers and hex nuts are used to secure
the buffer to the workbench. See figure-2.
Figure-2 Through Mount
"Direct Mount" is to simply secure the buffer
to the workbench using lag screws. See
figure-3.
Figure-3 Direct Mount
8