Mounting The Motor; Tensioning The Belt; Power Supply; Cutter Head Guard - Craftex CT056 Owner's Manual

CT056 6" WOODWORKING JOINTER

Mounting The Motor

Mount the motor on the top of the dust chute with the bolts provided. The bolt
heads should be in the chute.
Carefully place the jointer unit on top of the base and bolt into place. This unit is
heavy and will require assistance to lift
it and position it on top of the base.
When in position, place the drive belt
on the sheave of the motor and the
cutter head sheave.
Tensioning The Drive Belt
The illustration shows the correct way
to install and tension the motor drive
belt. When you are satisfied that the
motor is positioned correctly, securely
tighten the motor mount bolts.

Power Supply

The CT056 is pre-wired at 110 volts and requires a 15-amp circuit. It is
recommended that you use a dedicated circuit for the tool.

Cutter Head Guard

The shaft of the cutter head guard fits into a socket on the side face of the infeed
table. Loosen the locking screw, insert the shaft and tighten the locking screw.
Adjusting The Fence
With the fence in the 90-degree
position, use a combination square to
determine if the fence is accurate.
Should this not be the case, loosen the
fence vertical locking screw lever.
Fine-tune the adjusting bolt until the
fence is vertical.
To adjust the fence in the 45-degree
position, loosen the horizontal locking
screw lever and fine–tune the
adjusting bolt accordingly.
Assembly, Continued
8