Carriage Mounting Bracket - Craftex CX Series User Manual

Figure H
3. Carefully allow the motor to slide
downward, tensioning the V-belt with
the weight of the motor.
4. Looking from the top, sight down the V-
belt and pulleys and check that the
pulleys are parallel and aligned with
each other. (Fig. I )

If the pulleys are aligned,
retighten the motor mount
bolts and proceed to step 7

If the pulleys are NOT aligned,
proceed to steps 5 & 6.
5. Remove the V-belt, loosen the set
screws in the motor pulley and then
align the motor pulley with the
cutterhead pulley. If needed the motor
can be loosened and moved backward
and forward slightly to bring the pulleys
into alignment.
6. Tighten the set screws and replace the
V-belt. Repeat step 4 to check the
pulley alignment, they should be
perfectly aligned (Fig. I).
7. Now replace the back access cover on
the cabinet then tighten motor
mounting bolts.
Figure I

Carriage Mounting Bracket

Components & Hardware Required:
Carriage Mounting Bracket
Cap Screws M8-1.25 x 60
Lock Washers 8mm
Flat Washers
Tools required:
6mm Hex Key
1. Align the locating pins on the back of
the carriage mounting bracket with the
sockets on the jointer table as shown in
(Fig. J)
Figure J
12
Qty
1
4
4
4
Qty
1