7
Remote Programming
ADC Calibration Commands
ADC Calibration Commands
:CALibrate:ADC[:STARt]
:CALibrate:ADC:NEXT
:CALibrate:ADC:ABORt
122
The CALibration subsystem contains commands to re-calibrate the ADC of
the digitizer and to calibrate the deterministic latency in the data path to
another module.
The ADC calibration commands allow to re-calibrate the ADC of the
digitizer, to query the calibration status and to save and load calibration
data.
Command
:CALibrate:ADC[:STARt]
Description
The command starts the self-calibration of the ADC module.
In modules with single ended inputs, where a calibration requires an
NOTE
external calibration probe, this command starts the calibration of the
first channel.
Command
:CALibrate:ADC:NEXT
Description
The command starts the next step of the ADC module's self-calibration.
This command applies only to the modules with single ended inputs,
NOTE
where a calibration requires an external calibration probe.
Command
:CALibrate:ADC:ABORt
Description
The command aborts a running self-calibration of the ADC module.
Keysight M8131A 16/32 GSa/s Digitizer User's Guide