Returned Format
: TRIGger:EDGE:SOURce
Returned Format
: TRIGger:EDGE:SLOPe
Returned Format
Keysight M8131A 16/32 GSa/s Digitizer User's Guide
[:TRIGger:SWEep] {AUTO | TRIGgered}<NL>
Command
:TRIGger:EDGE:SOURce {EXTernal | CHANnel<N> |
SYNCinput}
Description
The command selects the source for trigger events.
<N> An integer, 1-4.
EXTernal Use the external trigger input.
CHANnel<N> Use an analog input channel.
SYNCinput Use the Sync Input. This trigger source must be selected in the
slave digitizer, when multiple digitizers are connected to allow
synchronous capture to memory or synchronous ODI streaming. The Sync
Output of the master digitizer must be connected to the Sync Input of the
slave digitizers.
Query
:TRIGger:EDGE:SOURce?
The query returns the current setting for the trigger source.
[:TRIGger:EDGE:SOURce] {EXTernal | CHANnel<N> | SYNCinput}<NL>
Command
:TRIGger:EDGE:SLOPe {POSitive | NEGative}
Description
The command sets the slope of the trigger source. The slope setting is
always the same for all trigger sources.
POSitive Trigger on a rising edge.
NEGative Trigger on a falling edge.
Query
:TRIGger:EDGE:SLOPe?
The query returns the current setting for the trigger slope.
[:TRIGger:EDGE:SLOPe] {POSitive | NEGative<N>}<NL>
Remote Programming
175
7