Table of Contents
Advertisement
7
Remote Programming
Common Commands
*IDN?
*CLS
*ESE
ESR?
*OPC
138
Read the instrument's identification string which contains four fields
separated by commas. The first field is the manufacturer's name, the
second field is the model number, the third field is the serial number, and
the fourth field is a revision code which contains four numbers separated
by dots and a fifth number separated by a dash:
Keysight Technologies, M8131A,<serial number>,
x.x.x.x-h
x.x.x.x= Soft Front Panel revision number, e.g. 2.0.0.0
h= Hardware revision number
Clear the event register in all register groups. This command also clears
the error queue and cancels a *OPC operation. It doesn't clear the enable
register.
Enable bits in the Standard Event Status Register to be reported in the
Status Byte. The selected bits are summarized in the "Standard Event" bit
(bit 5) of the Status Byte Register. The *ESE? query returns a value which
corresponds to the binary-weighted sum of all bits enabled decimal by the
*ESE command. These bits are not cleared by a *CLS command. Value
Range: 0–255.
Query the Standard Event Status Register. Once a bit is set, it remains set
until cleared by a *CLS (clear status) command or queried by this
command. A query of this register returns a decimal value which
corresponds to the binary-weighted sum of all bits set in the register.
Set the "Operation Complete" bit (bit 0) in the Standard Event register
after the previous commands have been completed.
Keysight M8131A 16/32 GSa/s Digitizer User's Guide
Advertisement
Table of Contents
