Trigger: Syncout[?]; Trigger:mode[?] - Keysight Technologies M8131A User Manual

7 Remote Programming
Returned Format

:TRIGger: SYNCout[?]

:TRIGger:MODE[?]

178
ABOVe This setting is only defined for negative slope and triggered sweep
mode (TRIGger:SWEep TRIGgered). The trigger event is generated, if the
signal characteristic of interest crosses the threshold (with negative slope)
after having been above the threshold for at least the holdoff time. The
trigger event is associated with the time the level was crossed.
BELow This setting is only defined for positive slope and triggered sweep
mode (TRIGger:SWEep TRIGgered). The trigger event is generated, if the
signal characteristic of interest crosses the trigger threshold (with positive
slope) after having been below the threshold for at least the holdoff time.
The trigger event is associated with the time the level was crossed.
Query :TRIGger:HOLDoff:TYPE?
The query returns the current setting for the holdoff type.
[:TRIGger:HOLDoff:TYPE] { NORMal | ABOVe | BELow }<NL>
Command
:TRIGger:SYNCout {0 | OFF | 1 | ON}
Description This command is used to support the synchronous start of the capture
operation on multiple digitizers. It enables or disables the output of trigger
pulses on the Sync Output. For synchronous operation the Sync Output of
the master digitizer must be connected to the Sync Input of the slave
digitizer. The capture is started by a received trigger event on the master
digitizer, which is distributed to all connected slave digitizers.
0 | OFF No trigger pulses are output on Sync Output.
1 | ON Trigger pulses are output on Sync Output.
Query :TRIGger:SYNCout?
The query returns, if output of trigger pulses on the Sync Output is enabled
or disabled.
Command
:TRIGger:MODE {EDGE}
Description The command sets the trigger mode. Currently, "Edge" is the only
supported mode.
Query :TRIGger:MODE?
The query returns the trigger mode.
Keysight M8131A 16/32 GSa/s Digitizer User's Guide