Display; Factory Setting - Danfoss AK-CC55 User Manual

User Guide | Controller for appliance control, AK-CC55
Display AK-UI55 Set
The values will be shown with three digits, and with a setting you can determine whether the temperature is to be shown in °C or in °F.
Lights up in event of:
Energy optimization
Cooling
Defrosting
Fan operation
The display can give the following messages:
-d- Defrost is in progress.
Err The temperature cannot be displayed due to a sensor error.
Err The display cannot load data from the controller. Disconnect and then reconnect the display.
ALA The alarm button is activated. The first alarm code is then shown.
- - - At top position of the menu or when max. value has been reached, the three dashes are shown in the top of the display.
- - - At bottom position of menu or when min. value has been reached, the three dashes are shown in the bottom of the display.
Loc The configuration is locked. Unlock by pressing (for 3 seconds) on the 'up arrow' and 'down arrow' simultaneously.
UnL The configuration is unlocked.
- - - The parameter has reached min. or max. limit.
PS A password is required for access to the menu.
Fan Appliance cleaning has been initiated via a contact. The fans are running.
OFF Appliance cleaning is activated and the appliance can now be cleaned.
OFF The main switch is set to Off.
SEr The main switch is set to service / manual operation.
CO2 Flashes: Will display in event of a refrigerant leakage alarm, but only if the refrigerant is set up for CO2.

Factory setting

If you need to return to the factory-set values, do the following:
- Cut off the supply voltage to the controller.
∧ ∨
- Keep up and down arrow buttons depressed at the same time as you reconnect the supply voltage.
" " " "
- When FAc is shown in the display, select "yes".
18 | BC308437742037en-000101
Lights in event of alarm — press on alarm button — alarm relay is reset — alarm code displayed — e.g. "A1"
Alarm codes are shown page 63.
Long press (3 seconds) gives access to the
information menu "InF"
Up arrow / Down arrow / Arrow to left:
Navigation in the menu and setting of values.
Long press (3 seconds) will start a defrost,
"-d-" is shown in the display.
Ongoing defrosting can be stopped by a long press.
SET:
Long press (3 seconds) gives access to the "SEt" menu.
If the operation is locked with a password, "PS" is shown. Enter the code.
Shows the setting for a chosen parameter / saves a changed setting.
Short press gives access to entering of the thermostat's cut-out limit.
© Danfoss | DCS (vt) | 2019.09